diff --git a/drivers/mmc/arm_pl180_mmci.c b/drivers/mmc/arm_pl180_mmci.c
index e267cd7..c4d94d1 100644
--- a/drivers/mmc/arm_pl180_mmci.c
+++ b/drivers/mmc/arm_pl180_mmci.c
@@ -357,13 +357,13 @@
 	.set_ios = host_set_ios,
 	.init = mmc_host_reset,
 };
-#endif
 
 /*
  * mmc_host_init - initialize the mmc controller.
  * Set initial clock and power for mmc slot.
  * Initialize mmc struct and register with mmc framework.
  */
+
 int arm_pl180_mmci_init(struct pl180_mmc_host *host, struct mmc **mmc)
 {
 	u32 sdi_u32;
@@ -377,9 +377,8 @@
 	writel(sdi_u32, &host->base->mask0);
 
 	host->cfg.name = host->name;
-#ifndef CONFIG_DM_MMC
 	host->cfg.ops = &arm_pl180_mmci_ops;
-#endif
+
 	/* TODO remove the duplicates */
 	host->cfg.host_caps = host->caps;
 	host->cfg.voltages = host->voltages;
@@ -393,20 +392,34 @@
 	*mmc = mmc_create(&host->cfg, host);
 	if (!*mmc)
 		return -1;
-
 	debug("registered mmc interface number is:%d\n",
 	      (*mmc)->block_dev.devnum);
 
 	return 0;
 }
+#endif
 
 #ifdef CONFIG_DM_MMC
+static void arm_pl180_mmc_init(struct pl180_mmc_host *host)
+{
+	u32 sdi_u32;
+
+	writel(host->pwr_init, &host->base->power);
+	writel(host->clkdiv_init, &host->base->clock);
+	udelay(CLK_CHANGE_DELAY);
+
+	/* Disable mmc interrupts */
+	sdi_u32 = readl(&host->base->mask0) & ~SDI_MASK0_MASK;
+	writel(sdi_u32, &host->base->mask0);
+}
+
 static int arm_pl180_mmc_probe(struct udevice *dev)
 {
 	struct arm_pl180_mmc_plat *pdata = dev_get_platdata(dev);
 	struct mmc_uclass_priv *upriv = dev_get_uclass_priv(dev);
 	struct mmc *mmc = &pdata->mmc;
-	struct pl180_mmc_host *host = mmc->priv;
+	struct pl180_mmc_host *host = dev->priv;
+	struct mmc_config *cfg = &pdata->cfg;
 	struct clk clk;
 	u32 bus_width;
 	int ret;
@@ -421,27 +434,28 @@
 		return ret;
 	}
 
-	strcpy(host->name, "MMC");
 	host->pwr_init = INIT_PWR;
 	host->clkdiv_init = SDI_CLKCR_CLKDIV_INIT_V1 | SDI_CLKCR_CLKEN |
 			    SDI_CLKCR_HWFC_EN;
-	host->voltages = VOLTAGE_WINDOW_SD;
-	host->caps = 0;
 	host->clock_in = clk_get_rate(&clk);
-	host->clock_min = host->clock_in / (2 * (SDI_CLKCR_CLKDIV_INIT_V1 + 1));
-	host->clock_max = dev_read_u32_default(dev, "max-frequency",
-					       MMC_CLOCK_MAX);
 	host->version2 = dev_get_driver_data(dev);
 
+	cfg->name = dev->name;
+	cfg->voltages = VOLTAGE_WINDOW_SD;
+	cfg->host_caps = 0;
+	cfg->f_min = host->clock_in / (2 * (SDI_CLKCR_CLKDIV_INIT_V1 + 1));
+	cfg->f_max = dev_read_u32_default(dev, "max-frequency", MMC_CLOCK_MAX);
+	cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
+
 	gpio_request_by_name(dev, "cd-gpios", 0, &host->cd_gpio, GPIOD_IS_IN);
 
 	bus_width = dev_read_u32_default(dev, "bus-width", 1);
 	switch (bus_width) {
 	case 8:
-		host->caps |= MMC_MODE_8BIT;
+		cfg->host_caps |= MMC_MODE_8BIT;
 		/* Hosts capable of 8-bit transfers can also do 4 bits */
 	case 4:
-		host->caps |= MMC_MODE_4BIT;
+		cfg->host_caps |= MMC_MODE_4BIT;
 		break;
 	case 1:
 		break;
@@ -449,19 +463,21 @@
 		dev_err(dev, "Invalid bus-width value %u\n", bus_width);
 	}
 
-	ret = arm_pl180_mmci_init(host, &mmc);
-	if (ret) {
-		dev_err(dev, "arm_pl180_mmci init failed\n");
-		return ret;
-	}
-
+	arm_pl180_mmc_init(host);
+	mmc->priv = host;
 	mmc->dev = dev;
-	dev->priv = host;
 	upriv->mmc = mmc;
 
 	return 0;
 }
 
+int arm_pl180_mmc_bind(struct udevice *dev)
+{
+	struct arm_pl180_mmc_plat *plat = dev_get_platdata(dev);
+
+	return mmc_bind(dev, &plat->mmc, &plat->cfg);
+}
+
 static int dm_host_request(struct udevice *dev, struct mmc_cmd *cmd,
 			   struct mmc_data *data)
 {
@@ -479,9 +495,7 @@
 
 static int dm_mmc_getcd(struct udevice *dev)
 {
-	struct arm_pl180_mmc_plat *pdata = dev_get_platdata(dev);
-	struct mmc *mmc = &pdata->mmc;
-	struct pl180_mmc_host *host = mmc->priv;
+	struct pl180_mmc_host *host = dev->priv;
 	int value = 1;
 
 	if (dm_gpio_is_valid(&host->cd_gpio)) {
@@ -501,12 +515,10 @@
 
 static int arm_pl180_mmc_ofdata_to_platdata(struct udevice *dev)
 {
-	struct arm_pl180_mmc_plat *pdata = dev_get_platdata(dev);
-	struct mmc *mmc = &pdata->mmc;
-	struct pl180_mmc_host *host = mmc->priv;
+	struct pl180_mmc_host *host = dev->priv;
 	fdt_addr_t addr;
 
-	addr = devfdt_get_addr(dev);
+	addr = dev_read_addr(dev);
 	if (addr == FDT_ADDR_T_NONE)
 		return -EINVAL;
 
@@ -527,6 +539,7 @@
 	.ops = &arm_pl180_dm_mmc_ops,
 	.probe = arm_pl180_mmc_probe,
 	.ofdata_to_platdata = arm_pl180_mmc_ofdata_to_platdata,
+	.bind = arm_pl180_mmc_bind,
 	.priv_auto_alloc_size = sizeof(struct pl180_mmc_host),
 	.platdata_auto_alloc_size = sizeof(struct arm_pl180_mmc_plat),
 };